Hi, I added the following to /etc/sysctl.conf: net.ipv4.ip_forward = 1 sysctl -p does not show any errors. So after a #service network restart, I see this: Shutting down interface eth0: [ OK ] Shutting down loopback interface: [ OK ] Disabling IPv4 packet forwarding: net.ipv4.ip_forward = 0 [ OK ] Bringing up loopback interface: [ OK ] Bringing up interface eth0: [ OK ] Bringing up interface eth1: Determining IP information for eth1... done. But a sysctl -p shows the right info after? Is this behavior normal?
I have seen the same thing. I think what is happening is that when you restart networking, it disables packet forwarding. When you start it, it will re-enable. After you start the network type:
"/sbin/sysctl net.ipv4.ip_forward" I expect that you will see "net.ipv4.ip_forward = 1" Please confirm. Barry _______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
