on 4-15-2008 5:46 AM Kai Schaetzl spake the following:
Did you use the HP utilities to set up an array on the controller before you tried to install?John wrote on Mon, 14 Apr 2008 23:26:59 -0400:Check your BIOS Settings for the controller. May be that it needs to set to "Mass Storage" if available in the HP Bios.There is nothing I can set regarding this. There is also a built-in HP SATA fakeRAID controller for the mainboard built-in SATA ports. I switched that off. I also switched SATA ports off now. There's nothing else in the BIOS I could try I think. There's also nothing in the controller's BIOS that seems to be fitting this description, the only hardware-related thing I can change there, is a hook interrupt or what they call it. I didn't dare to change that yet.According to this readme page for the latest driver at ftp://ftp.hp.com/pub/softlib2/software1/pubsw-linux/p1463703615/v44436/mpt linux-4.00.13.01-2.rhel5.i686.dd.gz.txt CentOS 5 should already contain a "default driver version contained in the Red Hat Enterprise Linux 5 installation CD"Then again the MPT Drivers for that controller may have been dropped for that controller.Well, I was going by their description which says that RHEL 5 comes with these drivers. Of course, that could still be wrong ...I do know several have been "End of Lifed" I know thisto be true for other high end server manufactures. Support for them ended in RHEL 4. So that would = CentOS 4 as well.It seems that RHEL 4 did not have the drivers on board. Their software configuration guide mentions that you need to install a driver (if I recall right). Unfortunately, the guide wasn't updated for RHEL, although they say they support RHEL 5 and 5.1 on this machine.Maybe I actually hit a different problem than I think. This is the first time that I need to install an extra driver for installation or use an external HBA SAS/SATA adapter. Some more information:During inital anaconda setup I can see that various mpt drivers get installed. It's too fast output at this time to read well thru ALT F3/F4, but it looks like the controller and SATA drives are found and handled under /dev/sda with no error. The drivers loaded are mtpbase, mptscsih, mptsas and scsi_transport_sas. After choosing eth0 as install source and retrieving the kickstart file setup asks me "unable to find any devices of the type needed for this installation type. Would you like to manually select your driver or sue a driver disk". The "manual" selection gives me a list of storage drivers. I then tried to use the driver given by HP which is a dd file and install it from a USB stick. I can select /dev/sdb1 and it shows the .dd files as the only one available. When I choose this it tells me "no devices of the appropriate type were found on the driver disk". At the same time ALT+F4 shows "unable to identify CD-ROM format" and F3 a line "modules to insert" that is empty. The dd file is a 1.440 floppy image it seems. Am I doing something wrong here?In case that matters: of course, I already set up the two drives in the LSI SAS utility for a RAID1 configuration and it shows them now as "LSILogicLogical Volume 3000" which seems to be quite ok to me.I'd appreciate any insight you might have. I'm going to try out their forums now and see how good they are.Kai
AFAIR you can only do that from the setup disk that came with your server, or download a new copy if you don't have it.
-- MailScanner is like deodorant... You hope everybody uses it, and you notice quickly if they don't!!!!
Attachment:
signature.asc
Description: OpenPGP digital signature
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
