Kernel-upgrade breaks forcedeth-driver (CentOS 4)

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]



Hi all,

Same system as my previous mail - Asus P5N32-E SLI motherboards, CentOS 4 x86_64.

The kernel-supplied forcedeth driver works in kernel-smp-2.6.9-55.0.9.EL (both with and without acpi=off), but after upgrading to kernel-smp-2.6.9-67.0.4.EL, networking does not start. After trying dhcp, ifconfig reports 17 dropped TX packets (all other counters are empty). Ethtool reports the same settings for working and non-working kernel, and both report the link arbitrated to 1000Mbps. Setting a manual address does not do anything useful either.

When booting with 55.0.9, networking works again.

This has also been confirmed on another system - 2.6.9-55.0.12.EL works, and 2.6.9-67.EL fails (but this system is not available for troubleshooting right now).

Also, the above system was attempted installed with CentOS 5 (.0 and later with 5.1), but this was aborted due to 'networking problems', so I am thinking that the problem possibly persists at least as late as the CentOS 5.1 install-kernel.

Any thoughts or suggestions?

Yours,
-S
--
Simen Thoresen - Dolphin ICS Systems Administrator
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos

[Index of Archives]     [CentOS]     [CentOS Announce]     [CentOS Development]     [CentOS ARM Devel]     [CentOS Docs]     [CentOS Virtualization]     [Carrier Grade Linux]     [Linux Media]     [Asterisk]     [DCCP]     [Netdev]     [Xorg]     [Linux USB]
  Powered by Linux