>Chris,
>
>I got the impression that the network
setup is as this example:
>
>Your laptop (192.168.1.x/255.255.255.0)
>
>Router (192.168.1.1/255.255.255.0)
>
>Xen (192.168.1.x/255.255.255.0)
>
>Well, you can't route from one physical
network to another over a router where source and destination has a ip in the
same netmask area. Perhaps you only use the >router
as a network switch since cheaper models have a built in switch... In this case
it's a switch rather then a router, some lousy home scale routers may rally
screw >up things since they don't have
switches, rather a couple of network interfaces separated with bridging and
firewall rules in a embedded Linux or BSD environment..
>
>
>- Nicolas
Nicolas,
I am following this thread with interest as a system I was about
to setup is using the same driver and in the same networking scenario! If in a
small segment with only one subnet and the default gateway on that subnet as
you describe above, the Xen machine even in bridged mode won’t have
connectivity if Dom0 has an ip on the same subnet? Giving the Xen machine an IP
on a different subnet would make it tricky to connect from another machine in
this setup?
Thanks!
jlc
|
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
