Hello,
I'am using a LSI 1068e OEM version from Super Micro (see lspci). I was
able to install a plain CentOS5 with the binary drivers I got from Super
Micro.
06:00.0 SCSI storage controller: LSI Logic / Symbios Logic Unknown
device 0059 (rev 04)
Subsystem: Super Micro Computer Inc Unknown device a180
Flags: bus master, fast devsel, latency 0, IRQ 10
I/O ports at e000 [size=256]
Memory at febfc000 (64-bit, non-prefetchable) [size=16K]
Memory at febe0000 (64-bit, non-prefetchable) [size=64K]
Expansion ROM at fe800000 [disabled] [size=2M]
Capabilities: [50] Power Management version 2
Capabilities: [68] Express Endpoint IRQ 0
Capabilities: [98] Message Signalled Interrupts: 64bit+
Queue=0/0 Enable-
Capabilities: [b0] MSI-X: Enable- Mask- TabSize=1
But if I try to load the XEN kernel or a newer kernel all I got is a
kernel panic, because the new kernel does not know about the megasr.ko
module that I installed from disk.
So I did the following (without final success):
- cp /lib/modules/2.6.18-8.el5/updates/*
/lib/modules/2.6.18-8.1.15.el5/updates
- depmod -a 2.6.18-8.1.15.el5
- created a new initrd-cpio file and copied megasr.ko into the lib
directory
The systems starts loading the kernel and its ramdisk, and then hangs:
Kernel panic - not syncing: VFS: Unable to mount root fs on
unknown-block (0,0)
I'am a bit lost, what else I can do to get this working?
Best Regards
--Michael
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
