Original the array was attach to an HP server via a Smart Array Controller.(which I didn't setup, I just inherited the problem) This controller no longer recognizes the array even though the front panel of the array indicates its intact. I then took the array and plugged it into my Centos server and it recognized it ... cat /proc/scsi/scsi Attached devices: Host: scsi0 Channel: 00 Id: 00 Lun: 00 Vendor: XD-T112- Model: 212R Rev: R0.0 Type: Direct-Access But with errors In dmesg have this: sda: Mode Sense: bf 00 00 08 SCSI device sda: drive cache: write back sda: unknown partition table sd 0:0:0:0: Attached scsi disk sda I have no experience with the Smart Array Controller, just what I read the past couple of days. Here's how it was mounted on the HP server /dev/cciss/c0d1 /stor02 ext3 defaults 1 1 Is there a way I can get the data off the array with my Centos server? Any help/suggestions/tips would be greatly appreciated, I've hit a brick wall. _______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos