I'm trying to install centos 5 on an old machine, a
Micron with a pentium III and 250 megs of ram. I'm
using the DVD image.
The media check said the DVD was OK.
Everything starts fine (both in graphics and text
modes), untl I get to the custom partition table. The
new system will go on hda, with the boot and root
partition reformatted (see below). I laid it out to
preserve the data on /home and another two partitions
with a lot of data on each. One of these is mounted
as /proj but Anaconda shows it as a giant swap
partition.
After I'm done with the formatting and mount points, I
say OK, and then nothing happens. I left it run for
over an hour, and then bailed out. Before rebooting, I
looked at the console messages. There were a couple of
warnings but no indications of anything fatal. Just
nothing for over an hour.
I'm downloading a new image (actually the CDs) just in
case the media's bad.
I also suspect the partition layout may be a problem.
It was done long ago on the first hard drive:
/boot 100 megs
/ 10 gigs
/home 10 gigs
extended ...
/proj 25 gigs
/opt 10 gigs
swap 500 megs
Once the CDs are in, I'll try again. If it fails, I'll
do a new partition table on the first hard drive -- I
have everything backed up.
If anyone has a better idea, or if I'm way off base,
let me know.
hda -> ST360021A, ATA 60 gig Seagate
hdb -> Maxtor 6Y160L0, ATA 150 gig
Thanks,
Barry
____________________________________________________________________________________
Be a better Globetrotter. Get better travel answers from someone who knows. Yahoo! Answers - Check it out.
http://answers.yahoo.com/dir/?link=list&sid=396545469
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
