Camron W. Fox wrote:
Alle,
I am trying to install CentOS 5 on a Dual Xeon 5160 FJ RX200 S3. The
RAID hardware is an internal LSI MPT 1068 SAS/RAID controller (LSI
1068SASIME-2300). I have downloaded the drivers (mptsas, mptscsih and
mptbase) and created the required floppy.
When I run linux dd after booting from either the DVD or Disk 1 of
the CentOS distro, it says it loads mptsas, mptbase and mptscsih and
then comes up with "No drivers of the appropriate type were found",
etc... Consequently, the RAID device is not found and no disks are
available for installation.
When I do this with RHEL5 Disk 1, the drivers load correctly and
there is no problem.
I went to the LSI Logic site to download the drivers directly from
there, but they apparently don't support RHEL5 as of yet for the
LSISAS1068.
Any assistance would be greatly appreciated.
Best Regards,
Camron
Alle,
Apparently, I should have just "trusted the process". Doing a regular
install *without* the using the FJ driver disk works just peachy.
Best Regards,
Camron
Camron W. Fox
Hilo Office
High Performance Computing Group
Fujitsu America, INC.
E-mail: cwfox@xxxxxxxxxxxxxx
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
