Thanks Robert,
I have a Terminal Services Server that will be behind the inside interface,
I need to forward hits on port 3389 eth1 to an IP address behind eth0.
Richard Veale
-----Original Message-----
From: centos-bounces@xxxxxxxxxx [mailto:centos-bounces@xxxxxxxxxx] On Behalf
Of Robert Spangler
Sent: Thursday, June 14, 2007 10:31 PM
To: CentOS mailing list
Subject: Re: BQ/CentOs port forwarding
On Thu June 14 2007 18:06, Richard Veale wrote:
> Just bought a new BQ/CentOS box with full NuOnce load (Linux
> 2.6.9-55.ELsmp, gcc 3.4.6, Red Hat 3.4.6-8, Apache 2.0.52, BQ 5102r), to
> replace my old Qube 3 pro, I have NAT setup (eth0 = inside, eth1 =
outside)
> but need to get port forwarding going. What is the best way?
Well it depends on what you are trying to forward But to turn on forward in
general use this;
/bin/echo 1 >/proc/sys/net/ipv4/ip_forward
--
Regards
Robert
Smile... it increases your face value!
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
