----- Original Message -----
----- "CentOS List" <centoslist@xxxxxxxxx> escreveu:
> >> > Set up md0 (Raid1) (sda,sdb)
> >> > Set up md1 (Raid1) (sdc,sdd)
> >> >
> >> > Set up md2 (Raid0) (md0,md1)
> >>
> >> ok. That sounds easy.. I tried to do md0. It ask for me a mount
> >> point.
> >> What should I mount it on?
> >
> > The only thing you mount at the end of the day is md2
> >
> > Are you trying to set this up in the installer or somewhere else?
>
> Yes. During the installing of CentOS 5. I had specified hda and hba
> as raid and when i wanted to create md0, it want me to supply a mount
> point.
> So i am stuck there.
As far as I know, the CentOS installer didn't allow a RAID 1+0
during install! But, I think you can setup this using RAID1 + LVM :
- Setup md0 (Raid1) (sda,sdb)
- Setup md1 (Raid1) (sdc,sdd)
- Setup LVM (md0+md1)
But i am stuck during the setup of md0 as it requires me to specified
a mount point.
Well, select the partition type as LVM not ext2/3 and it will not ask
for a mount point :)
So where do i mount /boot / and swap?
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
