Use df or df -P to see where are filesystems identified by LABEL (boot in
your case)
Use pvs (and also vgs, lvs) to see LVM layout.
Wojtek
On Mon, 16 Apr 2007, Benjamin Sher wrote:
> Date: Mon, 16 Apr 2007 14:13:33 -0400
> From: Benjamin Sher <delphi123@xxxxxxxxx>
> Reply-To: CentOS mailing list <centos@xxxxxxxxxx>
> To: CentOS mailing list <centos@xxxxxxxxxx>
> Subject: Formatting hdb?
>
> Dear friends:
>
> Using Centos 5.
>
> I have two physical drives. During install, I made sure to check hdb as well
> as hda. Both were listed as partitions (which is correct). But my fstab file
> does not show hdb. How do I make sure that hdb has been formatted and is part
> of my file system. If hdb is not formatted, how do I format it, please. Sorry
> for the question. I am a newbie.
>
> d[sher@localhost ~]$ df
> Filesystem 1K-blocks Used Available Use% Mounted on
> /dev/mapper/VolGroup00-LogVol00
> 74560920 5339640 65372680 8% /
> /dev/hda1 101086 11997 83870 13% /boot
> tmpfs 237428 0 237428 0% /dev/shm
> [sher@localhost ~]$
>
>
> [sher@localhost ~]$ cat /etc/fstab
> /dev/VolGroup00/LogVol00 / ext3 defaults 1 1
> LABEL=/boot /boot ext3 defaults 1 2
> devpts /dev/pts devpts gid=5,mode=620 0 0
> tmpfs /dev/shm tmpfs defaults 0 0
> proc /proc proc defaults 0 0
> sysfs /sys sysfs defaults 0 0
> /dev/VolGroup00/LogVol01 swap swap defaults 0 0
>
> Thank you so much.
>
> Benjamin
>
>
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
