Michael Velez wrote:
Yep, removed those lines. As for the pigtail, I didn't
switch from one to the other. The monitor on tail 1 works
fine. I want to get the 2nd tail working for my other
monitor. Or am I confused thinking that this card can
support 2 monitors?
The card is detected as a Quadro4 NV17GL 200/400. Do
you need any other info?
For the pigtails, I was just assuming one is primary so if you only have one
monitor, you should use that one. I may be wrong but I had an issue like
that when I installed my one monitor. You are correct in assuming it can
support two monitors.
Do you see any errors in the /var/log/Xorg.0.log file? Specifically look
for lines that start with (EE).
I have the same kernel and gcc. I have a quadro NVS 280 and have recompiled
drivers for the past two and a half years.
I don't know what else to tell you.
michael
First off, many thanks to you for you assistance, even though I haven't
gotten it yet. A small favor, would you be able to quickly write
something up for me as to the steps I should've taken? Or is there
something somewhere that I've missed?
Florin mentioned in another thread about trying ATrpms. I figure that's
worth a shot too. Or is that not a good idea?
--
--- David Woyciesjes
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
