Don Levey wrote:
Sadly, this did not work. I set the jumpers on the drives to SATA 1 (1.5GB)
but the installation routine did exactly the same thing as before (did not
automatically load the south bridge SATA controller, I selected via_sata
manually, then when it came time to partition I was told there were no
drives in the system).
What version of centos are you trying to install ? I am sitting here in
front of a A8V, and its working fine. I suggest you revert to factory
defaults on the bios, enable the promise sata interface, try centos-4.4
( btw, i run x86_64 on there, but that should not make a diff, the i386
should work fine as well )
- KB
--
Karanbir Singh : http://www.karan.org/ : 2522219@icq
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
