mike.redan@xxxxxxx wrote:
It kinda looks like he is looking to use return values to do his
scripting....
If so, try netcat.
nc -z -w3 192.168.1.1 80
That will return 0 on open port. 1 on close port. 1 on filtered port.
Waits 3 seconds for a response.
Wrap in a loop as needed...
Yes! You rock :).
Ugo
Mike
-----Original Message-----
From: centos-bounces@xxxxxxxxxx [mailto:centos-bounces@xxxxxxxxxx] On
Behalf Of Matt Shields
Sent: December 7, 2006 1:55 PM
To: CentOS mailing list
Subject: Re: Scripting port scans
Use nmap. Here I'm scanning my home network for any port 80 that's open
nmap -p 80 192.168.1.0/24
Matt Shields
Cyberbite Network - www.cyberbite.com
On 12/7/06, Ugo Bellavance <ugob@xxxxxxxxxxxxxx> wrote:
Hi,
I need to test one specific port on a serie of Ip addresses that I
own, I thought about using nmap or telnet, but both return the same
value, no matter if the port is open or filtered.
Anyone has an idea, before I start scripting to analyse the output of
the command?
Regards,
Ugo
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
