On Mon, 13 Nov 2006 at 1:00pm, Plant, Dean wrote
I thought I would give your suggestion a go and bought in a LSI 21320R
scsi card and installed a fresh copy of CentOS 4.4. Now on boot I get
the following error and the Overland Library is not detected. Did you
change any options in the LSI scsi bios?
No I didn't -- it all Just Worked(TM).
SCSI subsystem initialized
Fusion MPT base driver 3.02.62.01rh
Copyright (c) 1999-2005 LSI Logic Corporation
Fusion MPT FC Host driver 3.02.62.01rh
Fusion MPT SPI Host driver 3.02.62.01rh
mptbase: Initiating ioc0 bringup
ioc0: 53C1030: Capabilities={Initiator}
scsi0 : ioc0: LSI53C1030, FwRev=01033010h, Ports=1, MaxQ=222, IRQ=169
Vendor: HP Model: Ultrium 3-SCSI Rev: G33H
Type: Sequential-Access ANSI SCSI revision: 03
mptbase: ioc0: IOCStatus(0x0002): Busy
mptscsi: ioc0: attempting task abort! (sc=f7d01c80)
scsi0 : destination target 1, lun 1
command = Inquiry 00 00 00 3a 00
Your changer is on a different SCSI ID from the tape drive, right (rather
than on the same ID and a different LUN)? It's odd that it's hanging on
that inquiry.
Despite what you said about other OSs working with this setup, I'd check
your cables and termination real well. Have you done any fiddling with
the SCSI options on the library?
--
Joshua Baker-LePain
Department of Biomedical Engineering
Duke University
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
