[CentOS] How do you set the refresh frequency for the X server?

[Alfred von Campe <alfred@xxxxxxx>]

During the kickstart installation of the CentOS 4.3 systems I  
recently built, anaconda probed for the video card (Intel 945) and  
monitor (NEC MultiSync 2070NX).  The optimal setting for this monitor  
is 1600x1200 @ 60Hz.  The X server is configured to use 1600x1200,  
but it is using a higher refresh rate, which causes the monitor to  
display an error message, and it also locks you out of the on-screen- 
menu.  How do you translate a 60Hz refresh frequency into the  
appropriate horizontal sync and vertical refresh frequencies in the  
xorg.conf file?  I can't find anything to change in system-config- 
display.  Any suggestions?

Thanks,
Alfred

_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos