Les Mikesell wrote:
On Fri, 2006-06-09 at 22:58 +0800, Feizhou wrote:
I just looked at the boot sector on the 3 machines that I have running
software raid1. It looks like the installer got it right on all 3.
IIRC, one was installed as CentOS 4.1, another as 4.2, and another as 4.3.
The installer will install grub. Just not properly. If the first disk
dies, when the box comes up, the previous second disk grub stage 1 will
load but it will not look for the stage 2 on the current disk and
therefore fail.
That will depend on what your bios does when the first drive fails and
whether you've had to move it to make it boot at all. On the scsi
systems where I've used it, the 2nd drive will boot and everything
on the cable shifts up if the first drive fails or is removed.
IDE systems are different - and normally won't boot if a failed drive
is still connected.
Hmm, does it come back up on a scsi based system?
I cannot remember but if the second disk's grub stage 1 does get loaded,
it tries to load stage 2 from the 'second' drive which will not work and
the reason for the failure or whether it does load stage2 but stage2
looks in the wrong 'disk' for its config file.
So either way, it should also fail on a scsi system...
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
