On 6/1/06, Alfred von Campe <alfred@xxxxxxx> wrote:
On May 31, 2006, at 17:36, Rodrigo Barbosa wrote:
>
> On Wed, May 31, 2006 at 05:22:29PM -0400, Alfred von Campe wrote:
>> kickstart file via http, but then dies with a "installation exited
>> abnormally -- received signal 11" message. I've done this
>> successfully in the past. Can a misconfigured kickstart file cause
>> this problem? How can I debug this?
>
> In 90% of the cases, a signal 11 means faulty memory.
> In 9% of the cases, something wrong with the processor (usually
> overheating)
>
> 1%: Others reasons
>
> Suggestion: Running memtest86
I must be in the other 1% of reasons. I ran memtest86 and I also
tried it on other systems. These are brand new IBM (Lenovo)
ThinkCentre M52 systems with 4GB of RAM. On all systems it fails
with the same error. So I ask again, can a misconfigured kickstart
configuration file cause this problem? If not, how can I debug
this? How can I capture any logs from the kickstart session? None
of the virtual consoles appear to have a running shell where I can
access the system.
On a related note, what's the consensus on enabling hyperthreading on
a CentOS system? Good, bad, indifferent? The systems will be used
as developer workstations.
Thanks,
Alfred
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
--
Thx
Joshua Gimer
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
