I am running Asterisk@home on one of my systems here. It uses Centos
4.2. It does NOT have a GUI interface. Command line only at console
or via SSH (yeah, I know that I was working on another server to get
GUI tools working through SSH, but I am NOT going to muck with AAH build).
yum update is potentially dangerous, when it replaces the
kernel. You can loose all of your Zaptel driver setups and have to
rebuild them. This is a given, the first time you install AAH and
run yum update....
Now at
http://www.voip-info.org/wiki/view/Asterisk%40Home+Handbook+Wiki+Chapter+3
I was instructed to use NETCONFIG to setup up my network
information. Well it did for eth0, but not for eth1.
So question #1 is how to use netconfig to setup eth1 without messing with eth0.
#2) NETCONFIG did not setup my hostname and domain. I had to go
in with VI to resolv.conf and sysconfig/network. Is there a tool for this?
#3) How do I figure out which board is which. Other than looking
at the MAC address and using PCISNIFFER to then relate that to one of
the boards (well, one 'builtin'). Also how do I determine which
board is using which IRQ.
#4) Finally how can I change which IRQ a board is using. As one
of the boards is using the same IRQ as one of my Zaptel clone cards
(Tigerjet chips according to PCISNIFFER).
#4 leads into the 'more'.
This system has TWO FXO clone cards. One is working in AAH, the
other AMP does not see. Asterisk CLI flags one as "alarm" RED. and
does not report the IRQ of either board.
#5) How do I figure Centos has configured these two cards, and
what IRQs are used and maybe how to change the IRQs.
#6) Then how to get genzaptelconf to properly configure this card.
Barrs Law of Recursive futility
If you're smart enough to use one of these....
.....you can probably manage without one!
