i tried 4.2 on a hp lh3000 , its appearently a RAID issue , went back
to 3.6 and and running rock solid
Russ
----- Original Message -----
From: "Steve Huff" <shuff@xxxxxxxxx>
To: "CentOS mailing list" <centos@xxxxxxxxxx>
Sent: Friday, January 20, 2006 11:02 AM
Subject: HP NetServer LC2000r and LH6000r install woes
> hello folks!
>
> i've got four HP NetServers, two LC2000r and two LH6000r. the CentOS 4.2
> ServerCD can't see hard drives on any of them.
>
> each machine has a HP NetRAID controller; the LC2000rs have a NetRAID-1Si
> and the LH6000rs have an Integrated NetRAID. each controller has three
> 9GB drives, two mirrored and one hotspare.
>
> each machine boots ok (the LC2000rs need "linux noacpi" or they complain
> about being in a weird power management state and panic), each loads the
> megaraid driver, but none of them can see any volumes.
>
> fixes i have already tried:
>
> 1) on the LH6000rs i have disabled "Smart IRQ" reallocation; on the
> LC2000rs i have disabled "Reserve PCI Bus Numbers" as described in this
> document:
>
> http://tldp.org/HOWTO/HP-HOWTO/hp-hardware.html#AEN792
>
> these fixes have made the megaraid driver stop complaining about IRQ
> conflicts or routing errors.
>
> 2) i have tried switching each NetRAID controller from I20 to "Mass
> Storage" mode; no change.
>
> 3) i have tried manually adding the i2o_block driver; no change.
>
> has anyone encountered similar problems with this hardware? better yet,
> has anyone resolved them? any other ideas?
>
> do i need to do anything to the logical volumes on the NetRAIDs other
> than create and initialize them?
>
> i'm currently downloading the full CentOS install media, in case this is
> some sort of deficiency in the ServerCD.
>
> thanks,
> steve
>
> ---
> If this were played upon a stage now, I could condemn it as an improbable
> fiction. - Fabian, Twelfth Night, III,v
>
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
>
