> Actually, I don't think mii-tool gives that info (at least, it didn't > give the current speed when I tried it). Plus, it's deprecated. > ethtool on the otherhand does give that info. > mii-tool does give the info requested as seen below: [root@insanity ~]# mii-tool eth0: negotiated 100baseTx-FD, link ok however ethtool gives significantly more. Apparently I'm a bit behind the times in my networking scripts. I was unaware that mii-tool was considered deprecated. Good to know. -- Jim Perrin System Architect - UIT Ft Gordon & US Army Signal Center
network running at 10 or 100, how to tell
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
- Subject: network running at 10 or 100, how to tell
- From: jperrin at gmail.com (Jim Perrin)
- Date: Wed Jan 4 14:18:30 2006
- In-reply-to: <43BBD5B3.3060103@xxxxxxxxxxx>
- References: <43BBD14B.9030509@xxxxxxxxxxxxxxx> <302ce8b50601040547j77831ee8vec0c2d8ef4bd09d2@xxxxxxxxxxxxxx> <43BBD5B3.3060103@xxxxxxxxxxx>
- Follow-Ups:
- network running at 10 or 100, how to tell
- From: Benjamin J. Weiss
- network running at 10 or 100, how to tell
- References:
- network running at 10 or 100, how to tell
- From: Jerry Geis
- network running at 10 or 100, how to tell
- From: Jim Perrin
- network running at 10 or 100, how to tell
- From: Benjamin J. Weiss
- network running at 10 or 100, how to tell
- Prev by Date: OT: Linux boot floppy to install over net
- Next by Date: network running at 10 or 100, how to tell
- Previous by thread: network running at 10 or 100, how to tell
- Next by thread: network running at 10 or 100, how to tell
- Index(es):
 |