ssacli start rebuild?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]



Hi,

is there a way to rebuild an array using ssacli with a P410?

A failed disk has been replaced and now the array is not
rebuilding like it should:


   Array A (SATA, Unused Space: 1  MB)

      logicaldrive 1 (14.55 TB, RAID 1+0, Ready for Rebuild)

      physicaldrive 1I:0:1 (port 1I:box 0:bay 1, SATA HDD, 4 TB, OK)
      physicaldrive 1I:0:2 (port 1I:box 0:bay 2, SATA HDD, 4 TB, OK)
      physicaldrive 1I:0:3 (port 1I:box 0:bay 3, SATA HDD, 4 TB, OK)
      physicaldrive 1I:0:4 (port 1I:box 0:bay 4, SATA HDD, 8 TB, OK)
      physicaldrive 2I:0:5 (port 2I:box 0:bay 5, SATA HDD, 4 TB, OK)
      physicaldrive 2I:0:6 (port 2I:box 0:bay 6, SATA HDD, 4 TB, OK)
      physicaldrive 2I:0:7 (port 2I:box 0:bay 7, SATA HDD, 4 TB, OK)
      physicaldrive 2I:0:8 (port 2I:box 0:bay 8, SATA HDD, 4 TB, OK)


I'd expect the rebuild to start automatically after 1I:0:4 was replaced.
Is the new drive being larger than the old one (4-->8) causing issues?


_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos



[Index of Archives]     [CentOS]     [CentOS Announce]     [CentOS Development]     [CentOS ARM Devel]     [CentOS Docs]     [CentOS Virtualization]     [Carrier Grade Linux]     [Linux Media]     [Asterisk]     [DCCP]     [Netdev]     [Xorg]     [Linux USB]


  Powered by Linux