> I completed the install as described below which went well.
>
> I then copied the contents of /boot/efi to /boot/efi_copy using
>
> cd /boot
> rsync -acr efi/ efi_copy
>
> I then installed grub2 on sdb
>
> yum install yum install grub2-efi-modules
> grub2-install /dev/sdb
>
> everything ran as expected with no errors. The instructions then said to
> test
> the install by powering off and swapping sda and sdb. Instead, I just
> unplugged sda.
>
> When I booted the system loaded straight into a grub> prompt.
>
> I powered off and reconnected sda hoping to be able to continue
> experimenting.
> However, even with sda reconnected it just boots into a grub> prompt.
>
> Anyone got suggestions what to do next?
If you boot, istn't there a way to get into an EFI boot menu where you can
see the different EFI boot entries? Maybe you can see there what is wrong
now.
On the other hand, maybe you could even reinstall and try to configure
/boot/efi on RAID1 as it was described by others in this thread?
Regards,
Simon
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
