On 11/01/2017 03:06 PM, Gordon Messmer wrote:
On 11/01/2017 07:55 AM, Scott Gennari wrote:
/etc/xen/scripts/network-bridge-pcl
#/bin/sh
dir=$(dirname "$0")
"$dir/network-bridge" "$@" vifnum=1 netdev=eth2 bridge=xen-dmz2
"$dir/network-bridge" "$@" vifnum=3 netdev=eth0 bridge=xen-dmz1
Do you get any error output when you run:
/etc/xen/scripts/network-bridge vifnum=1 netdev=eth2 bridge=xen-dmz2
If not, try:
bash -x /etc/xen/scripts/network-bridge vifnum=1 netdev=eth2
bridge=xen-dmz2
And if all else fails, set up a bridged interface by hand:
brctl addbr xen-dmz2
ip link set dev eth2 up
brctl addif xen-dmz2 eth2
--
Hi Gordon,
Thanks for this, I was able to get xen-dmz1 & 2 setup using the manual
method you described and get the domain/guests back online.
Much appreciated,
Scott
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
