On 01/24/17 19:00, Gordon Messmer wrote:
On 01/24/2017 02:14 PM, m.roth@xxxxxxxxx wrote:
So, it installed happily.
Then wouldn't boot.
What did the storage configuration look like, exactly? I'd guess that you put
one partition on each disk, combined those in a RAID1 MD array, made than an
LVM physical volume, and then created filesystems and swap on LVs. But that's
a lot of guesses. Did you use MBR partitions or GPT? Are you booting under
BIOS or UEFI? Where do your partitions start? Did you create a standard MD
RAID volume and LVM or a partitionable RAID volume and partitions?
No. Brand new machine, pulled it out of the box and racked it. NOTHING on the
internal SSDs. Made an md RAID 0 on the raw disks - /dev/sda /dev/sdb. No
partitions, nothing. However, when I bring it up, fdisk shows an MBR with no
partitions. I can, however, mount /dev/md127p3 as /mnt/sysimage, and all is there.
Did I need to make a single partition, on each drive, and then make the RAID 1
out of *those*? I don't think I need to have /boot not on a RAID.
mark
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
