On 12/12/2016 07:29 AM, Gary Stainburn wrote:
On Monday 12 December 2016 12:15:10 David Both wrote:
The lm_sensors package is required for the sensors module of glances to
work. After installing lm_sensors, run sensors-detect. The sensors
command will show the sensors detected and their current values. glances
should then display the sensor readings.
Somewhere tucked in the back of my mind a memory is screaming no. Wasn't there
a problem with lm_sensors where we were all told to remove / not install it
because of serious problems with the package possibly even breaking things.
Presumably that's no longer the case
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
If there was such a problem it is very far in the past or it only shows
up on hardware I don't have. I have never had any problems with the
lm_sensors package breaking things and I have been using it for years.
--
*********************************************************
David P. Both, RHCE
Millennium Technology Consulting LLC
Raleigh, NC, USA
919-389-8678
dboth@xxxxxxxxxxxxxxxxxxxxxxxxx
www.millennium-technology.com
www.databook.bz - Home of the DataBook for Linux
DataBook is a Registered Trademark of David Both
*********************************************************
This communication may be unlawfully collected and stored by the National
Security Agency (NSA) in secret. The parties to this email do not consent to the
retrieving or storing of this communication and any related metadata, as well as
printing, copying, re-transmitting, disseminating, or otherwise using it. If you
believe you have received this communication in error, please delete it
immediately.
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
