Everyone,
I am putting together a new CentOS 7 mail server for our organization
and am having some difficulty getting clamav to work with the clamav-
milter for sendmail.
I have set /etc/clamd.d/scan.conf to use clamscan as the user as well
as root as the user and the status command of systemctl results in the
same error messages :
● clamd@scan.service - Generic clamav scanner daemon
Loaded: loaded (/usr/lib/systemd/system/clamd@scan.service; enabled;
vendor preset: disabled)
Active: failed (Result: start-limit) since Thu 2016-09-29 17:53:11
CDT; 1min 38s ago
Process: 1891 ExecStart=/usr/sbin/clamd -c /etc/clamd.d/scan.conf --
foreground=yes (code=exited, status=1/FAILURE)
Main PID: 1891 (code=exited, status=1/FAILURE)
Sep 29 17:53:11 IrGw3.EcCare.com systemd[1]: Unit clamd@scan.service
entered failed state.
Sep 29 17:53:11 IrGw3.EcCare.com systemd[1]: clamd@scan.service failed.
Sep 29 17:53:11 IrGw3.EcCare.com systemd[1]: clamd@scan.service holdoff
time over, scheduling restart.
Sep 29 17:53:11 IrGw3.EcCare.com systemd[1]: start request repeated too
quickly for clamd@scan.service
Sep 29 17:53:11 IrGw3.EcCare.com systemd[1]: Failed to start Generic
clamav scanner daemon.
Sep 29 17:53:11 IrGw3.EcCare.com systemd[1]: Unit clamd@scan.service
entered failed state.
Sep 29 17:53:11 IrGw3.EcCare.com systemd[1]: clamd@scan.service failed.
I have tried running :
/usr/sbin/clamd -c /etc/clamd.d/scan.conf --foreground=yes
with the foreground set to yes and no and with the user set in
scan.conf as clamscan or root and it works fine.
I have not been able to figure out what is happening with the command :
systemctl start clamd@scan
The same error messages occur at boot with this command as well as on
the command line.
Do any of you have suggestions.
Thanks much,
Greg Ennis
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
