Hello everyone,
When I run the command localedef -c -i en_GB -f UTF-8 en_GB.utf-8 the
command runs with no errors but running locale still shows:
LANG=en_US.UTF-8
LANGUAGE=en_US
LC_CTYPE="en_US.UTF-8"
LC_NUMERIC="en_US.UTF-8"
LC_TIME="en_US.UTF-8"
LC_COLLATE="en_US.UTF-8"
LC_MONETARY="en_US.UTF-8"
LC_MESSAGES="en_US.UTF-8"
LC_PAPER="en_US.UTF-8"
LC_NAME="en_US.UTF-8"
LC_ADDRESS="en_US.UTF-8"
LC_TELEPHONE="en_US.UTF-8"
LC_MEASUREMENT="en_US.UTF-8"
LC_IDENTIFICATION="en_US.UTF-8"
LC_ALL=
I rebooted the machine just in case, that didn't help
Running locale -a shows many options including en_GB and en_GB.utf-8
The only way that I have been able to change the locale is by editing
/etc/sysconfig/i18n. If I change that and then reboot it changes the
locale. However what confuses me about this is that I can only change
to a new locale, I can't seem to go back to a previous locale.
For example, I started with en_US, changed it to en_GB which worked.
Then I tried to change it back to en_US and nothing happened.
After that I decided to try to see if it was only failing with en_US
or if it would always fail. So I tried changing from en_GB to en_NZ
which worked. Then I tried to go from en_NZ to en_US which failed.
At this point I don't care as much about getting the right locale.
I just want to know why it will change to something new,
but not change back to a previous locale.
I have tested this on 6.4, 6.5, and 6.8 and get the same results.
First I was running it on a VM using QEMU and VMM but I tried it
on a physical machine and nothing changed. All of these were
fresh installs, the first thing I did after completing the install
was try to change the locale.
Any advice or explanation is appreciated, thanks in advance.
Zach
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
