jtj and Eero, thank you for replying.
please excuse delay in replying. see *additions* at end.
On 07/14/2016 03:40 AM, Eero Volotinen wrote:
> 2016-07-14 11:36 GMT+03:00 Jose Maria Terry Jimenez <jtj@xxxxxxxxxxxxx>:
>> El 14/7/16 a las 9:01, ge lignored escribió:
>>
>>> greetings to one and all.
>>>
>>> a new iso burn w/ centos 6.8 failed to boot on a 686 32 bit mid tower
box,
>>> but will boot a 32 bit laptop, so i dropped back to 6.7 which did boot.
>>>
>>> after install with centos 6.7, attempt to upgrade fails with 'repolist
0'.
>>>
>>> all desire repo files have enable = 1.
>>>
>>> searched thru past 4 yrs of personal archives, nothing found related to
>>> 'repolist 0'.
>>>
>>> ran web search for 'repolist 0' and 'repolist = 0' with all hits related
>>> to repo files having 'enable = 0'.
>>>
>>> any suggestions/ideas/clues as to solution of problem greatly
appreciated.
>>>
>>>
>> Hello
>>
>> Never seen this but i'd try
>>
>> yum repolist all
>>
fails with 'repolist: 0'.
>> Lists the enabled repos?
>>
fails with 'repolist: 0'.
>> Did you tried
>>
>> yum clean all
>>
>> Before the upgrade?
>>
fails with 'repolist: 0'
>> I think this happens in RHEL if you have no active suscription, but not
>> applicable to CentOS.
>>
do not have rhel installed so can not test.
> You can also add yum -v or -vv to debug issue more.
>
> Eero
>
both fail with 'repolist: 0'.
*additions*
made a file by file comparison between 2 systems of yum directories, both
have same files. i did not go thru /lib and /var files.
side-note: tried to add this gmail account to thunderbird, ran into
problems with gmail. next replies may be with a diff account setup
using thunderbird.
jtj and Eero, i thank you again for replying. much appreciated.
--
peace out.
CentOS GNU/Linux 6.8
tc,hago.
g
.
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
