On 2/17/2016 4:56 PM, Chris Adams wrote:
Once upon a time, Mustafa Mohammed<netechie@xxxxxxxxx> said:
>I am trying to setup a backup system using Bacula on CentOS 6.7 installed on eserver x345 but cannot find the drivers
I set one of those up many years ago, probably RHEL 3 timeframe. No
drivers are necessary for the library, although you will have to find a
differential SCSI card that is still supported to connect it (don't know
about that; I haven't touched parallel SCSI in ages, and the TL891 was
probably the last high-voltage differential device I used).
ooof, if that thing is HVD, then plugging it into a regular SCSI card
will likely blow up the card, and could fry the SCSI interface on the
library too.
however, this manual,
http://h10032.www1.hp.com/ctg/Manual/c00626568.pdf suggests there's
two versions, HVD and regular fast-wide SE scsi. quite a bit of
cabling is required.
--
john r pierce, recycling bits in santa cruz
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
