On 16/12/15 17:47, m.roth@xxxxxxxxx wrote:
> The other admin I work with seems to have found a bug in the installer.
> The setup is: two internal SSD drives. Once the GUI gets to "select drive
> to install on", he goes to <ctl><alt><f2>, creates a RAID 1, and
> partitions it, regular MBR (they're small). 1G for /boot as the first
> partition, 2G for swap as the second partition, and the rest for / as
> partition 3. fdisk shows the partition types correctly.
>
> Back to the GUI, select the MD drive... and /boot's fine, / looks ok...
> but the one for swap shows with 0 bytes.
>
> Anyone else seen this behavior?
this might be down to when anaconda does its disk scan, and when the
parts were created by hand. Ideally, just use anaconda to do the same
thing and you should be fine.
--
Karanbir Singh
+44-207-0999389 | http://www.karan.org/ | twitter.com/kbsingh
GnuPG Key : http://www.karan.org/publickey.asc
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
