I assume you are using one of the boards described here?
http://www.intel.com/support/services/smartconnect/sb/CS-033108.htm
On 11/19/2015 10:43 AM, Birta Levente wrote:
It is in AHCI, never was changed
On 19:26, Thu, Nov 19, 2015 Gordon Messmer <gordon.messmer@xxxxxxxxx> wrote:
On 11/19/2015 12:54 AM, Birta Levente wrote:
I tried today morning on RHEL too ...
The ISDCT tool does not work on supported OS neither
I think everyone focused on your problem with the vendor, who didn't
support your OS, and ignored the fact that the tool worked when the
drives were connected to a secondary controller. The OS never caused a
problem for the tool, only for the vendor's support staff.
So, again, check your BIOS settings and make sure the SATA ports are in
the standard AHCI mode.
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
--
-=-
Sent my from my laptop, may not be able to respond timely
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
https://lists.centos.org/mailman/listinfo/centos
