Our network admin blocked ports (don't know why - i asked him 2 weeks before I started to troubleshoot the system). Everything is fine now, thanks for help.
-----Original Message-----
From: Mark Milhollan [mailto:mlm@xxxxxxxxxxxxx]
Sent: Monday, December 29, 2014 9:21 PM
To: Mateusz Guz
Subject: RE: (py)curl error 7
On Mon, 29 Dec 2014, Mateusz Guz wrote:
>Ip -6 a shows no output
>
>after "visual" inspection i don't see any ipv6 addresses assigned to my eth interfaces
>
>On Mon, 29 Dec 2014, Mateusz Guz wrote:
>>On Sun, 28 Dec 2014, Mark Milhollan wrote:
>>>On Fri, 26 Dec 2014, Mateusz Guz wrote:
>
>>>>created /etc/modprobe.d/ipv6_disable.conf file with
>>>>alias net-pf-10 off
>>>>alias ipv6 off
>>>>options ipv6 disable=1
>>>
>>>These only take effect if you reboot or unload the modules manually.
>>
>>Tryning not to reboot, when unloading I get the message that the modules is in use.
>>I think that forcing the unload is too dangerouse, read that it might resolve in kernel panic.
>
>Forcing an unload wouldn't be wise. You must stop using the module then
>you can unload it. Busy usually means you have IPv6 addresses on some
>interfaces -- ip -6 addr flush dev ethX.
>
>
>/mark
>
Sorry, you'll have to find where else you are using IPv6.
/mark
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
