On 1/5/2015 7:14 AM, Philippe BOURDEU d'AGUERRE wrote:
Since Centos 6.6 update (kernel 2.6.32-504), the controller doesn't
initialize at boot. Reverting to kernel 2.6.32-431 allows server to
boot fine.
works here fine on the 9261, which is an OEM version of the same card
with the connectors in a different orientation... you might check your
LSI firmware revision.
# uname -rv
2.6.32-504.1.3.el6.x86_64 #1 SMP Tue Nov 11 17:57:25 UTC 2014
# cat /etc/redhat-release
CentOS release 6.6 (Final)
# dmesg |grep LSI
mpt2sas0: LSISAS2008: FWVersion(14.00.01.00), ChipRevision(0x03),
BiosVersion(07.27.00.00)
scsi 0:0:1:0: Enclosure LSI CORP SAS2X28 0717 PQ: 0 ANSI: 5
scsi1 : LSI SAS based MegaRAID driver
scsi 1:0:8:0: Enclosure LSI CORP SAS2X36 0717 PQ: 0 ANSI: 5
scsi 1:2:0:0: Direct-Access LSI MR9261-8i 2.12 PQ: 0 ANSI: 5
scsi 1:2:1:0: Direct-Access LSI MR9261-8i 2.12 PQ: 0 ANSI: 5
scsi 1:2:2:0: Direct-Access LSI MR9261-8i 2.12 PQ: 0 ANSI: 5
# /opt/MegaRAID/MegaCli/MegaCli64 -ShowSummary -aAll
System
Operating System: Linux version 2.6.32-504.1.3.el6.x86_64
Driver Version: 06.803.01.00-rh1
CLI Version: 8.02.16
Hardware
Controller
ProductName : LSI MegaRAID SAS 9261-8i(Bus 0, Dev 0)
SAS Address : 500605b003bbef10
FW Package Version: 12.12.0-0046
Status : Need Attention
BBU
BBU Type : iBBU
Status : Remaining Capacity is Low
Enclosure
Product Id : SAS2X36
Type : SES
Status : OK
Product Id : SGPIO
Type : SGPIO
Status : OK
......
--
john r pierce 37N 122W
somewhere on the middle of the left coast
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
