On 10.05.2014 18:36, CS_DBA wrote:
> Hi All;
>
> I have a new server we're setting up that supports EFI or Legacy in the bios
>
> I am a solid database guy but my SA skills are limited to what I need to
> get by
>
> 1) I used EFI because I wanted to create a raid 10 array with 6 4TB
> drives and apparently I cannot setup gpt partitions via parted in legacy
> mode (at least that's what I've read - is this true?)
When you say legacy mode do you mean BIOS or the CSM ("Compatibility
Support Module") of the UEFI firmware?
BIOS cannot boot from GPT partition but the CSM mode of the UEFI
firmware should be able to. You really want to go with plain UEFI though
if your system supports it.
> 2) I installed the OS on 2 500GB drives, I used to do all my installs
> with software RAID (mirrored) without LVM as follows:
> - create 2 raid partitions (one on each drive) for swap, /boot and /
> - create a raid1 device for each set of partitions above
>
> The installer would not let me proceed without a /boot/efi partition I
> tried to create a raid partition on each drive for this and create a
> /boot/efi raid disk but when I doit this way in the installer I no
> longer see the "EFI SYSTEM Partition" as an option for the filesystem
> type so this did not work either.
>
> I ended up doing hardware raid for the OS drives and software raid for
> the 6 4TB data drives. It works but I prefer to do software raid for
> everything so we ca have standard methods of monitoring for bad drives.
>
> Is there a way to setup software raid with EFI?
No. The UEFI Firmware needs to access to this partition before it can
boot the OS so anything that needs to have the OS running (like a
software raid) cannot work.
What you can do is create the partition on both disks, point the
installer to only the first disk and then later copy the files over to
the partition on the other disk so that if the first disk dies you can
still boot using the second one.
The partition can be tiny (just a couple of megabytes), should be the
first partition on the disk (though I think this is not strictly
necessary), should be formatted as FAT32, and should be given a type
GUID of "C12A7328-F81F-11D2-BA4B-00A0C93EC93B" which means "EFI System
partition" so that the UEFI firmware can find it.
You *should* be able to create the other partitions (including /boot) as
software raid though I've not done this myself yet so I'm not 100%
certain on that.
> Do I need to add a /boot/efi partition only to one of the 2 OS drives?
> If so how do I recover if we loose the drive with the /boot/efi partition?
>
> Is it required to use LVM to do this?
>
> Thanks in advance
>
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
