I had to install C5 on a dev server for various reasons (legacy system
support and so forth). This dev server is a HP DL180 G6, with a
SmartArray P410 raid card... I've installed hpacucli via the RPM from
HP's site, but its not finding the controller... C5 (64 bit) is using
the default CCISS drivers for this card.
# hpacucli ctrl all show config
Error: No controllers detected.
lspci -v reports...
06:00.0 RAID bus controller: Hewlett-Packard Company Smart Array G6
controllers (rev 01)
Subsystem: Hewlett-Packard Company Smart Array P410
Flags: bus master, fast devsel, latency 0, IRQ 66
Memory at fbc00000 (64-bit, non-prefetchable) [size=2M]
Memory at fbbff000 (64-bit, non-prefetchable) [size=4K]
I/O ports at d800 [size=256]
Expansion ROM at fbb00000 [disabled] [size=512K]
Capabilities: [40] Power Management version 3
Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [70] Express Endpoint, MSI 00
Capabilities: [ac] MSI-X: Enable+ Count=16 Masked-
Capabilities: [100] Advanced Error Reporting
Kernel driver in use: cciss
Kernel modules: cciss
--
john r pierce 37N 122W
somewhere on the middle of the left coast
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
