That is a software RAID controller, only works if you install HP's
driver first. Or switch to AHCI mode for individual disks.
See this article https://access.redhat.com/site/articles/118133
Thomas
On 03/03/2014 11:57 AM, Kenny Noe wrote:
> Also I have the FBWC module installed to allow RAID 5.
>
> --Kenny
>
>
> On Mon, Mar 3, 2014 at 2:52 PM, Kenny Noe <knoe501@xxxxxxxxx> wrote:
>
>> Here is the system.
>>
>>
>> HP ML350e G8 servers. They use the HP Dynamic Smart Array B120i raid
>> controllers.
>>
>> Thanks! --Kenny
>>
>>
>> On Mon, Mar 3, 2014 at 2:07 PM, John R Pierce <pierce@xxxxxxxxxxxx> wrote:
>>
>>> On 3/3/2014 10:54 AM, Kenny Noe wrote:
>>>> OK so what am I doing wrong?? Apparently anaconda is still reading 4
>>>> independent disk instead of a single 3 TB "disk". How do I get the
>>>> installer to recognize the single RAID disk?
>>>
>>> not going to read the whole thread, what sort of raid controller does
>>> this system have?
>>>
>>>
>>>
>>> --
>>> john r pierce 37N 122W
>>> somewhere on the middle of the left coast
>>>
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
