Jason T. Slack-Moehrle wrote:
> I am having an issue where eth1 is throwing some messages and stops
> responding. Restarting networking doesn't work and also just bringing down
> eth1 with 'ifdown' doesn't fix it. I have never seen anything like these
> messages:
>
> eth1: no IPv6 routers present
> r8169 0000:03:00.0: eth1: rtl_counters_cond == 1 (loop: 1000, delay: 10).
> r8169 0000:03:00.0: eth1: rtl_chipcmd_cond == 1 (loop: 100, delay: 100).
> r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25).
<...>
> r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25).
> r8169 0000:03:00.0: eth1: rtl_phy_reset_cond == 1 (loop: 100, delay: 1).
> r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25).
<snip>
> r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25).
> r8169 0000:03:00.0: eth1: link up
>
> [root@mail jtsm]# lspci | grep -i net
> 02:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network
> Connection
> 03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
> RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 01)
Googling on rtl_counters_cond finds a lot of folks talking about "laptop
mode" error, and somebody mentions "zero configuration", which I assume
they mean zeroconf. Is this a laptop? Is this wired or not? If it's wired,
and not a laptop, I'd shut down avahi-daemon and chkconfig it off (and the
same with NetworkMangler, er, Manager), and see what happens.
Another possibility, if wired, check your patch cord, and make sure it's
plugged in securely at both ends.
mark
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
