Further investigation.
If I create a route-eth0 file and put this in it:
default 192.168.122.1 dev eth0
I get this upon network restart:
Error: either "to" is duplicate, or "192.168.122.1" is a garbage.
Which this page:
http://www.centos.org/docs/5/html/5.1/Deployment_Guide/s1%2dnetworkscripts%2dstatic%2droutes.html
says I will get if the default route is set via DHCP. So, the system is
seeing the default route, and apparently even trying to set it, but it's not
lasting.
I'm really lost on this one.
j
On Wednesday, August 21, 2013 13:48:02 Joshua J. Kugler wrote:
> I have a CentOS 6.4 VM that is getting its DHCP information from dnsmasq (a
> libvirt instance). However, it is not applying the routing information.
> Attached is a tcpdump of the dhcpc output. You'll see:
>
> Default-Gateway Option 3, length 4: 192.168.122.1
>
> However, when I run 'route -n', I get:
>
> # route -n
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> Iface 192.168.122.0 0.0.0.0 255.255.255.0 U 0 0
> 0 eth0 169.254.0.0 0.0.0.0 255.255.0.0 U 1002 0
> 0 eth0
>
> Any ideas as to why the default route/gateway information isn't being
> applied?
>
> j
--
Joshua J. Kugler - Fairbanks, Alaska
Azariah Enterprises - Programming and Website Design
joshua@xxxxxxxxxxx - Jabber: pedahzur@xxxxxxxxx
PGP Key: http://pgp.mit.edu/ ID 0x73B13B6A
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
