CentOS 6.3, x86_64.
I have noticed when building a new software RAID-6 array on CentOS 6.3
that the mismatch_cnt grows monotonically while the array is building:
# cat /proc/mdstat
Personalities : [raid6] [raid5] [raid4]
md11 : active raid6 sdg[5] sdf[4] sde[3] sdd[2] sdc[1] sdb[0]
3904890880 blocks super 1.2 level 6, 512k chunk, algorithm 2 [6/6] [UUUUUU]
[==================>..] resync = 90.2% (880765600/976222720) finish=44.6min speed=35653K/sec
# cat /sys/block/md11/md/mismatch_cnt
1439285488
The mismatch count grows until the assembly is complete, and then remains
at its highest value. A subsequent check resets it to zero (immediately)
and everything is fine thereafter. The device is not in use by any other
system component. I have reproduced this on several different systems; it
always happens with CentOS 6.3 and never with CentOS 5.x and earlier (in
5.x, mismatch_cnt always stays at zero while assembling). I am using whole
drives in this example, but it's the same if I use partitions instead. The
count, size and type of drives appears to have no bearing.
Perhaps just a curiosity, but I'm curious as to why it does this.
Steve
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
