On 12/22/11 3:28 PM, Joseph L. Casale wrote:
>> i'm configuring a storage server with CentOS 6.2, it uses a LSI MegaRAID
>> >SAS controller, I'm using LSI's megacli to configure the storage...
>> >Any ideas on how to get drive failure notifications out of this
>> >system? I'm configuring hot spares but I'd still like some sort of
>> >notification when a drive has failed so the spare can be replaced.
> I've tried countless times to get the LSI snmp agent designed just for this
> to work in CentOS 5 and 6, no luck.
>
> Resorted to a pathetic snmp extend that runs megacli, sigh...
I just installed the Linux MSM package from LSI...
I had to add these packages to a minimal 6.2 install for what its worth...
*
yum install libstdc++.i686 compat-libstdc++-33.i686 libX11 libX11.i686 libXi libXi.i686 libXtst libXtst.i686 xauth net-snmp net-snmp-utils csh
The X stuff was required by the GUI manager, I suspect if you did a
agent-only install, that wouldn't be needed.
I'm a total novice when it comes to snmp. but i'm reading some
howto's and stumbling around.
--
john r pierce N 37, W 122
santa cruz ca mid-left coast
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
