I have a system that I just installed with CentOS 4.0. It is an HP
NetServer E 60 with dual CPUs and 1G RAM. There is an Adaptec AIC-7895
built into the motherboard.
On bootup, I get this:
(scsi0:A:1): 11.626MB/s transfers (5.813MHz, offset 8, 16bit)
(scsi0:A:1:0): data overrun detected in Data-in phase. Tag == 0x2.
(scsi0:A:1:0): Have seen Data Phase. Length = 255. NumSGs = 1.
sg[0] - Addr 0x03ace40 : Length 255
(scsi0:A:1:0): data overrun detected in Data-in phase. Tag == 0x3.
(scsi0:A:1:0): Have seen Data Phase. Length = 255. NumSGs = 1.
sg[0] - Addr 0x03ace40 : Length 255
(scsi0:A:1:0): data overrun detected in Data-in phase. Tag == 0x2.
(scsi0:A:1:0): Have seen Data Phase. Length = 255. NumSGs = 1.
sg[0] - Addr 0x03ace40 : Length 255
scsi scan: 255 byte inquiry failed with code 458752. Consider
BLIST_INQUIRY_36 for this device
Vendor: WDIGTL Model: WDE18300 ULTRA2 Rev: 1.30
Type: Direct-Access ANSI SCSI revision: 02
scsi0:A:1:0: Tagged Queuing enabled. Depth 4
SCSI device sdb: 35761710 512-byte hdwr sectors (18310 MB)
SCSI device sdb: drive cache: write back
sdb: sdb1
Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0
How do I use BLIST_INQUIRY_36? Is there anything else I can try to fix this
error?
Also, is there a searchable archive for this list?
Bowie
