Anne Wilson wrote:
On 23 August 2011 10:46, Tony Mountifield <tony@xxxxxxxxxxxxx> wrote:
In article <CAJfU-f7nCz+iamXzg5rQ0VZAELctBCNcNFySYykAapXw5CeG6g@xxxxxxxxxxxxxx>,
Anne Wilson <cannewilson@xxxxxxxxxxxxxx> wrote:
On 22 August 2011 20:50, Dennis Jacobfeuerborn <dennisml@xxxxxxxxxxxx> wrote:
One of the first things I do after the installation of a system is a yum
install postfix followed by a yum remove sendmail. No need to deal with
alternatives if you don't intend to deal with sendmail anyway.
I removed sendmail - but it also removed clamav-milter. When I tried
to re-install clamav-milter it would have pulled sendmail back in so I
aborted. Advice?
milters are specific to sendmail. clamav-milter is a linkage between
ClamAV and sendmail, so you don't need it with postfix. If you want to
use ClamAV, you will need to find out how to link it with postfix, but
it won't be by using clamav-milter.
OK, that's fine, then. In the past I ran scans via cron - which I've
set up again. However, I'm back with the original problem of not
receiving root mail - and not receiving any local messages that should
be routed by the /etc/postfix/transport.db
I use amavisd and clamav/clamd from rf repo - instructions on setup are
on the CentOS wiki - has always just worked for me with 5.x
HTH
Anne
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
begin:vcard
fn:Rob Kampen
n:Kampen;Rob
org:Team Torman Realty, LLC
adr:;;13019 Water Point Blvd;Windermere;FL;34786;USA
email;internet:rkampen@xxxxxxxxxxxxxxxxxxxx
tel;work:407-876-4108
tel;fax:407-876-3591
tel;home:407-876-4854
tel;cell:407-341-3815
note:LCAM & CPM Candidate
url:Search 1000's of homes instantly at www.robkampen.com
version:2.1
end:vcard
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
