On Thu, 14 Jul 2011, Devin Reade wrote:
> To: CentOS mailing list <centos@xxxxxxxxxx>
> From: Devin Reade <gdr@xxxxxxx>
> Subject: Re: Burning DVDs (was: CentOS 6 x86_64 DVD doesn't boot)
>
> --On Thursday, July 14, 2011 09:53:07 AM -0500 Trey Dockendorf
> <treydock@xxxxxxxxx> wrote:
>
>> I had an smililar issue using the CentOS 6 DVD with a DVD-RW. The same
>> install disk worked perfectly on another system. I ended up having to use
>> the Netinstall CD to do the install.
>
> This is often a side effect of what I have been told is a poor specification
> in the DVD industry regarding writing at > 1x speed, in that certain
> requirements were set for that speed but not for higher speeds.
>
> I have had much better luck with DVD data portability if I always
> burn DVDs at 1x (or as close to it as the DVD firmware will allow),
> particularly when it comes to burning on one system and reading on
> another.
Hello Devin. I heard that about audio CD's as well. Some
that are burnt on a PC at home will not play properly on a
car CD player. The answer was to burn at a lower speed as
possible.
I try to burn my data CD's and DVD iso's at a low speed as
possible.
Kind Regards,
Keith Roberts
>
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
>
--
-----------------------------------------------------------------
Websites:
http://www.karsites.net
http://www.php-debuggers.net
http://www.raised-from-the-dead.org.uk
All email addresses are challenge-response protected with
TMDA [http://tmda.net]
-----------------------------------------------------------------
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
