On 10.6.2011 21.42, Les Mikesell wrote:
> I thought the point of using vim instead of something more appropriate
> for scripting was that you already knew how to use it.
I only wrote that I know vim *better* than sed, awk or perl. Obviously
there is a lot about vim that I don't know.
> Why not do:
> vim -W script testfile
> and go through the motions you know (which can include 1G to go to the
> 1st line and G to go to the last).
> Then run
> vim -s script realfile
> to do the same actions again.
Ok, that helped me along. For some reason the motions (like 1G0 for
beginning of file, or G$ for last char in file) work, when the script is
called from command-line with -s flag (vim -s myscript myfile). But they
don't work when the script is called from inside vim (:source myscript).
I wonder why.
However, this script does more or less what I want - transforms a
tab-text file to a comma-separated (CVS) file:
:% s/\t/","/g
:% s/\r\n/\r/g
:% s/\n/"),\r("/g
1G0I("^[
Gdd
G$xa;^[
:w
Comments to lines:
1) replace tabs
2) make line endings regular
3) insert quotes and brackets to end & beginning fo each line
4) handle the beginning of file
5) remove the last line (created by this script)
(the command G works, but it rings the bell for some reason)
6) handle the end of file
7) write file
So this was my first-ever vim script. So far I am not convinced about
vim scripting (ok, I was warned, too)... Test cycle is slow (modify
script, quit the realfile, open realfile again with vim -s script).
Verbal error messages would be useful. There is supposed to be
"integrated debugger". I would like to know more.
- Jussi
--
Jussi Hirvi * Green Spot
Suvilahdenkatu 1 B 78 * 00500 Helsinki * Finland
Tel. +358 9 493 981 * Mobile +358 40 771 2098 (only sms)
jussi.hirvi@xxxxxxxxxxxx * http://www.greenspot.fi
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
