Hello,
I'm running a CentOS 5.6 server through linode. I am atempting to
configure it for ipv6, previously this had been done though not by me
on a ubuntu box so the hardware can take it. I've got an ipv6 tunnel
through Hurricane Electric and at a shell prompt have done the
following:
ifconfig sit0 up
ifconfig sit0 inet6 tunnel ::IPV4 Address
ifconfig sit1 up
ifconfig sit1 inet6 add IPV6 Address
route -A inet6 add ::/0 dev sit1
Testing that with a ping6 works fine. I then want it to persist across
reboots. So I added the following to /etc/sysconfig/network:
NETWORKING_IPV6=yes
IPV6_DEFAULTDEV=sit1
and I made /etc/sysconfig/network-scripts/ifcfg-sit1
DEVICE=sit1
BOOTPROTO=none
ONBOOT=yes
IPV6INIT=yes
IPV6TUNNELIPV4=IPV4 Address
IPV6ADDR=IPV6 Address
Reboot the box, check sit1 and it has an ip address. Running that
ping6 command says the network can't be reached. I have to take the
interface down and rerun those above commands manually. I'd appreciate
any suggestions.
Thanks.
Dave.
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
