On 05/05/2011 08:01 AM Brunner, Brian T. wrote:
> centos-bounces@xxxxxxxxxx wrote:
>> At Thu, 05 May 2011 07:44:52 -0400 CentOS mailing list
>> <centos@xxxxxxxxxx> wrote:
>>
>>>
>>> On 05/05/2011 07:13 AM, Timothy Murphy wrote:
>>>> Is there a standard way of copying a working system
>>>> from one machine to another with different partitions?
>>> You could also utilize cloning software, such as the client version
>>> of drbl, clonezilla livecd.
>>>
>>> You could also do a direct copy with dd onto a connected drive.
>> Warning: dd is not a good choise if the source and desination
>> drives/partitions are *different* sizes.
>
> Different block mappings will also give you grief.
> .:. The drives must be identical manufacturer and model, down to the
> firmware revision.
> dd is not a backup tool in the general sense.
I had doubts about dd also. But last year, when I needed to upgrade to
a larger drive, I used it and it worked fine. I bought a new drive (of
course of larger size... different manufacturer too), put it into a
drive enclosure, plugged that new drive into my USB port, and ran dd to
copy the entirety of hda to hdb. Shutting down the machine, I swapped
the hard drives and booted with the new drive and-- viola!-- new bigger
drive with everything running just like on the old drive. I didn't have
to reconfigure anything; even the networking worked on the new drive
without touching anything. The only thing I did on the new drive was to
create a new partition from all the extra new hd space I had. Indeed,
this is a multi-boot machine and all OSs on it copied over just fine.
In addition, all my linux partitions are encrypted, and all that copied
over perfectly as well.
One tip: Use dd's smallest block size (BS). I did this copy using dd
several times, starting with 4k, then 2k block sizes and the new disk
had problems when I tried to use it. IIRC, I had to rachet down to 256
to get a working drive. And this took eight or ten hours to copy an 80G
drive.
Another tip: in your BIOS the parameter for the hard drive should
probably be Auto-Detect if your source and destination drives aren't
identical. That's generally the default anyway.
Final tip (I think): For me, my machine A and machine B were the same
machine... so of course the hardware was absolutely identical. Using dd
might not work if the hardware on A and B are too different from one
another.
hth,
ken
--
"Truth is the most valuable thing we have, so I try to conserve it."
--Mark Twain
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
