Re: E1000 eth1 link flakiness - causes??

[Frank Cox <theatre@xxxxxxxxxxx>]

On Mon, 27 Dec 2010 17:37:50 -0500
E Westphal wrote:

> I've tried all the obvious things. Cables, router ports, rebooting etc.
> It's quite strange. From a cold bootup, it's fine. Then about 45 minutes
> later it starts to act up. None of the obvious things seem to help.
> Then, about 90 minutes after bootup, everything is fine again! Rock
> solid! Ethtool and anything else I've tried fails to yield any hints,
> thus my question to all of you.

It sounds very much like  a hardware issue, more specifically  a cold solder
joint whose properties change as the unit warms up.

-- 
MELVILLE THEATRE ~ Melville Sask ~ www.melvilletheatre.com
www.creekfm.com - FIFTY THOUSAND WATTS of POW WOW POWER!
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos