Thanks for all the help.
By the way I did install centos 5.5 in text mode and everything went fine .cthe server to the network and then found that i was not able to ping the gateway
when i do a network restart i see that eth0 comes up normally
also when i do a modprobe eth0 im returened back to prompt with no errors
the switch port shows the link up
ifconfig shows the interface is up and running
how could I know that the driver is installed correctly .. or any way i could know that my interface is up and working correctly
thanks and regards
if you need more details i would highly apprecite if you could ask please
regards
simon
On Dec 14, 2010 5:18pm, Ross Walker <rswwalker@xxxxxxxxx> wrote:
> On Dec 13, 2010, at 11:49 PM, Nico Kadel-Garcia nkadel@xxxxxxxxx> wrote:
>
>
>
>
>
> > On Mon, Dec 13, 2010 at 10:01 AM, benedict dcunha
>
>
> > sylvan.dcunha@xxxxxxxxx> wrote:
>
>
> >> Dear All,
>
>
> >>
>
>
> >> We have a new SUN BLADE X6270 SERVER MODULES and i am trying to install
>
>
> >> centos 5.5 64 bit . the installations starts fine but when it reaches the
>
>
> >> point inialthe X server it says initialization done but then gives a fatal
>
>
> >> error and stops
>
>
> >
>
>
> > Install in text mode: type "linux text" at the installation init
>
>
> > screen. It's not as flexible, but it avoids this failed detection of
>
>
> > your graphics chipset or video card.
>
>
>
>
>
> Or use the 'vnc' option to make it available over vnc instead then connect from any vnc capable device to do the installation.
>
>
>
>
>
> -Ross
>
>
>
>
>
> _______________________________________________
>
>
> CentOS mailing list
>
>
> CentOS@xxxxxxxxxx
>
>
> http://lists.centos.org/mailman/listinfo/centos
>
>
>
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
