Hi List, I am running a x86_64 Centos server, after a reboot the network has decided to not work.. this particular machine has 8 eth ports eth0-7. eth0 and eth3 were bonded (mode 1 ) after reboot the bond did not work. It came up OK but no data was passing through it. all other interfaces on the machine were working. I decided to remove the bond, so after removing the bond i was left with eth0 using the same IP as the bond used. however it still does the same thing, it starts up with no errors but i cannot even ping the default gateway, tcpdump shows nothing on the interface. I have made sure of the following * no iptables installed * kernel modules for the NIC are loaded with no errors * the bond kernel module is not installed / all bond configs have been removed Below is some info on the interface, it should be noted that all others are OK the only 2 that were having the issue are eth0 and eth3 (the ex-bonded ones) server1:/etc/sysconfig/network-scripts# ip route | grep 172.18 172.18.16.0/24 dev eth0 proto kernel scope link src 172.18.16.1 default via 172.18.16.254 dev eth0 # ifconfig eth0 eth0 Link encap:Ethernet HWaddr 00:24:49:C8:66:98 inet addr:172.18.16.1 Bcast:172.18.16.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:7223 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 b) TX bytes:463918 (453.0 KiB) Interrupt:226 Memory:dc000000-dc012800 If you look closely TX and RX are massively different, but I am not seeing anything on tcpdump even there is a large number of TX packets. Any ideas? Nathan _______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos